24
TEC-67398-2
Technical description Prizrak-5S BT
Resetting
to default values
There is a special procedure provided for resetting the immobilizer to default values, once the procedure is com
-
pleted the system’s nonvolatile memory is cleared of all non-default settings — such as a vehicle make and model,
PIN code combination and etc.
If the Immobilizer is installed on a vehicle:
1.
Unpower the immobilizer.
2.
Press and hold pressed the built-in PB (see «Immobilizer connection diagram»).
3.
Still holding the button pressed plug the device back into the connector (sypply power). There will be
intermittent continuouse beeps.
4.
Release the button (wait until the intermittent beeps are teminated).
5.
Turn the ignition ON and complete an authentication procedure (Enter PIN code and/or wait until a Slim-tag
is identified) — the confirmatory trill will sound.
6.
Wait for the intermittent continuous beeps signifying that the immobilizer has been reset to the default
settings. Unplug the device (unpower the immobilizer). This will reset all immobilizer features to the default
settings.
In case if the immobilizer is not installed on a vehicle:
The reset can be carried out in 3 ways:
1.
Using the built-in button provided that the factory PIN code hasn’t been changed and the vehicle hasn’t
travelled 10 km after installing the Immobilizer system.
2.
By entering PUK code with the built-in button.
3.
By installing the immobilizer module on the same vehicle model. (considering that you know the PIN code
and/or you have at least one Slim-tag).
The actions sequence for the first two ways:
1.
Press and hold the built in progrmming button (see «Immobilizer connection diagram»).
2.
Still holding the PB plug the device in (supply power to it). The immobilizer will start emiting continuous
beeps.
3.
Release the button, wait until the short beeps are terminated.
4.
Enter PIN code «2» using the built-in programming button if the vehicle hasn’t travelled 10 km after installing
the system or enter PUK code. The confirmation trill will sound if everything is done correctly.
5.
Wait for continuous beeps signifying that the module is now reset to the default settings.
6.
Only an authorized user is permitted to scratch off the protective film of the plastic card and enter PUK
code.
