Teac LT-1, Owner'S Manual

Page: 42 / 88

42
ENGLISH
Specifications
TUNER Section
Frequency Range(FM):
87.50 MHz to 108.00 MHz
Frequency Range(AM):
522 kHz to 1,620 kHz
CD PLAYER Section
Frequency Response:
20 Hz to 20 kHz(±1dB)
Wow and Flutter:
Unmeasurable
SPEAKER SYSTEM Section
Type:
65 mm 1-way x 2
80 mm subwoofer x 1
Impedance:
8 ohms (L & R)
8 ohm (subwoofer)
GENERAL
Total Output Power:
15 W
Power Requirements:
230 V, 650 Hz
Power Consumption:
40 W
Dimension ( W x H x D ):
357 x 205 x 247.5 mm
(including the remote holder)
Weight:
5.8 kg
Standard Accessories:
Remote Control Unit (RC-910) x 1
Owner’s Manual x 1
Warranty Card x 1
< Design and specifications are subject to change
without notice.
< Illustrations may differ slightly from production
models.
Troubleshooting
If you have problems with your system, look through
this chart and see if you can solve the problem yourself
before calling your dealer or TEAC service center.
General
No power
e Check the connection to the AC power supply.
No sound.
e Adjust the volume.
e If muting is on, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV set or similar
appliances. Install the unit further from them, or
turn them off.
Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e If a TV is near the unit, turn it off.
e Rotate the unit or antenna wire for the best
reception position.
CD Player
Cannot play.
e Load a disc with label side up.
e If the disc is dirty, clean the surface of the disc.
e Don’t use scratched, damaged or warped discs.
e Depending on the quality of the disc and/or the
condition of the recording, some CD-R discs may
not be playable.
e CD-RW discs cannot be played on this unit.
e Copy-protected discs may not be playable.
Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Don’t use scratched, damaged or warped discs.
Remote Control Unit
Remote control doesn’t work.
e If the batteries are dead, change the batteries.
e Use remote control unit within the range (5m/15ft)
and point at the front panel.
e Clear obstacles between the remote control unit
and the main unit.
e If a fluorescent light is near the unit, put it off.