Seite / Page 70 / 85
Electric Crimping Machine AT-300
IS412-94328 Rev. B
INFORMATION
+
To ensure fatigue-proof use, the user has to take a working position where the machine is
at the right height and the foot pedal is accessible. The foot pedal has to be installed in a
stable position. The position of the foot pedal should be chosen in that way, that a free
access will be possible.
INFORMATION
+
Over pressing the foot pedal will trip the safety button. It will rotate to the 3 o’clock position
and the machine will not function. To reset the safety button, rotate it counter-clockwise to
the 12 o’clock position.
+
If you release the safety button on the machine or the foot pedal, the crimping process will
be interrupted. If you press the safety button of the machine and the foot pedal again
simultaneously, the crimping process will be continued until its completion.
9.1
Crimping Process with SDE, CSE 30 or ERGOCRIMP Adapter
INFORMATION
+
It is only possible to operate the machine in full crimping cycle mode
when using the
SDE, CSE 30 or ERGOCRIMP adapter!
Crimping Process in Full Crimping Cycle Mode
:
1. Open the dies by depressing the lever of the adapter.
2. Keep it depressed and insert the crimp contact in the die profile or locator. Please pay
attention to the correct profile assignment and to the correct positioning within the crimp
profile!
3. Release the lever. The dies close automatically and hold the contact.
4. Insert the wire/cable which is stripped acc. to the specifications and position it for crimping.
5. Press the foot pedal and simultaneously one of the safety buttons on the right or left side
of the machine to start the crimp process.
6. Keep the foot pedal and the safety button pressed until the crimp cycle is finished.
7. Depress the lever of the adapter and remove crimped contact.
9.2
Crimping Process with HTV10 Adapter
Crimping Process in Full Crimping Cycle Mode
:
1. Insert the crimp contact in the die profile or locator. Please pay attention to the correct
profile assignment and to the correct positioning within the crimp profile!
2. Insert the wire/cable which is stripped acc. to the specifications and position it for crimping.
3. Press the foot pedal and simultaneously one of the safety buttons on the right or left side
of the machine to start the crimp process.
4. Keep the foot pedal and the safety button pressed until the crimp cycle is finished.
5. Remove crimped contact.
