Seite / Page 59 / 85
Electric Crimping Machine AT-300
IS412-94328 Rev. B
5
Transport and Installation
5.1
Transport
The weight of the electric Crimping Machine AT-300 is approx. 33 lbs.
CAUTION
+
To lift the crimping machine use the handle recesses on the machine.
ATTENTION
+
Wear suitable safety shoes when transporting the machine.
5.2
Installation
ATTENTION
+
Position the electric Crimping Machine AT-300 on a flat surface and assure the stability of
the machine. Ensure that the table or bench is stable enough to support the machine in
normal use.
+
Assure an appropriate table height. The table height is dependent on the position of the
operator, (work in sitting or standing position) according to prEN 894-4:2004, Table A.1.
+
The crimping machine has no own light source. Assure appropriate illumination of the
working place. (EN 1837:1999 – chapter 4.2: “The general value of illumination has to be
500 lx [...]").
Place the foot pedal on the floor. No other place is allowed. The foot pedal must be movable,
so that the operator has the possibility to change his position for ergonomic and production
needs.
ATTENTION
+
Place the cables on the floor so that they do not cause a trip hazard.
+
Do not lay the foot pedal in aisles or walkways.
+
During transport and installation of the machine wear suitable safety shoes.
INFORMATION
+
To ensure fatigue-proof use, the user has to take a working position where the machine is
at the right height and the foot pedal is accessible. The foot pedal has to be installed in a
stable position. The position of the foot pedal should be chosen in that way, that a free
access will be possible.
