409-35001
Rev C
58
of 92
For example
, assume the format of the model numbers being scanned is “PCB_XXXXX_MODEL” and
the correct board model number is “45612”. This means the correct model number string will be
“PCB_45612_MODEL”
. The portion of the model number string that must be parsed out starts at
character number 5, so “5” is entered into the “Parse substring starting at character number” field.
Because
the model number is 5 digits long, “5” is entered into the “Number of characters to parse” field
as well. Because at least 9 digits are required to read the full model number, "9" will be entered into the
"Minimum Data Length" field.
Finally, “45612” is entered into the “When parse substring matches field”
since that is the exact substring from the model number that must be verified (see Figure 59).
Figure 59
Sequence Editor
Purpose
The Sequence Editor (Figures 52, 53, and 54) is used to enter and store the data about the board
(including board physical characteristics and connector locations) and the pressing sequence. All
connectors and conditions to be used on the board being programmed must be defined in the connector
or condition database before the press data file can be generated.
The Sequence is saved in an sqlite database. When generating a new press program, it may be
convenient in some cases to open an existing press file and do a “Copy” to duplicated the Sequence and
a “Save” to store the sequence under a new sequence
name.
Entries
NOTE
Not all entries described are applicable to every type of press.
