409-32023
Rev
B
36 of 41
Figure 57
4. If the feed arm does not enter the gage block as shown in Figure 58, loosen the four latch plate
screws as shown in Figure 58, and move the latch plate.
Figure 58
5. Install the quick-release pin through the gage block and feed arm. If the quick-release pin does not
pass completely through the feed arm, loosen feed arm screws as shown in Figure 59, and move the
feed arm.
Figure 59
6. Re-tighten all the loose hardware.
7. Select the Apply button in the Feeder Page screen.
8. Remove the calibration assembly.
Feeder Calibration Gage
Gage Block Position
Feed Arm Does Not Enter Gage Block
Four Latch Plate Screws
Downloaded From
