409-32023
Rev
B
40 of 41
6.
MAINTENANCE
6.1.
Normal Preventive Maintenance and Lubrication
Follow the instructions given in the respective machine manuals.
6.2.
System III Feeder Maintenance
One Million Cycles of Feeder Operation
Every one million cycles of feeder operation, perform the following recommended preventive maintenance
procedures:
1. Remove electrical power from the machine.
2. Disassemble the rear guard cover, and remove the feeder guard.
3. Clean any accumulated debris from the ball screw and linear rails.
4. Inspect for any damaged parts or excessive bearing clearance.
5. Lightly lubricate ball screw and linear rails with lithium EP NLGI No. 2 grease. Refer to Figure 61.
6. Apply light machine oil to feed arm plunger and pivot hole. Refer to Figure 61.
Figure 61
7. Re-install the guards, and calibrate feeder.
DANGER
To avoid personal injury, the feeder should not be operated without guards in place. The feeder guard is an integral structural
element required for proper function of feeder.
Ten Million Cycles of Feeder Operation
Every ten million cycles of feeder operation, perform the following recommended preventive maintenance
procedures:
1. Disconnect electrical power from the machine.
2. Dis-assemble the rear guard cover, and remove the feeder guard.
3. Loosen the coupler clamp screws, and remove the servo motor.
4. Remove the coupler from the servo motor, and install a new coupler. Note that the coupler set-up
dimension is given on the assembly drawing.
5. Re-assemble the servo motor, and tighten the remaining coupler screws.
6. Reassemble guards, and calibrate feeder.
7. Connect power.
Grease Here
Oil Here
Grease Here
Downloaded From
