409-32023
Rev
B
23 of 41
— Use the Enter key to enter fields, activate a highlighted pushbutton, and acknowledge message
boxes and save changes.
— Use the Cancel key to cancel an operation and exit from some entry fields without saving data.
NOTE
Pressing the Cancel key repeatedly will exit any field return the user to the Run menu.
Feeder Control Keys
The Feeder Control keys and indicators are shown in Figure 34.
CONTROL KEY OR INDICATOR
DESCRIPTION
Retract Feed Finger Key
Pressing and holding this key moves (retracts) the feed to the programmed position.
Extend Feed Finger Key
Pressing and holding this key moves (extends) the feed to the programmed position.
Feed In Retracted Position/Pitch Adjustment Indicator This indicator lights when the feed finger is retracted. In this position, the feed pitch
may be adjusted. See Note 1.
Feed In Extended Position Feed Adjustment Indicator
This indicator lights when the feed finger is extended. In this position, the terminal
feed position over the anvil may be adjusted. See Note 1 and Note 2.
Increase Feed/Pitch Adjustment Key
If at the feed in extended position, holding this key will extend the terminal feed
position over the anvil. If at the feed retracted position, holding this key will shorten
the feed pitch. Adjustments will be lost unless entered before using other Motion
keys (except the Reduce Feed/Pitch Adjustment key.) Refer to Note 1.
Reduce Feed/Pitch Adjustment Key
This indicator lights when the feed finger is retracted. In this position, the feed pitch
may be adjusted. See Note 1.
Feed Full-Cycle Key
Pressing and holding this key will run a complete (full) cycle at normal speed.
Note 1: When adjusting the terminal feed position over the anvil, the distance between the extended and retracted feed finger positions (the
feed pitch) does not change. Therefore, changing the extended feed finger position automatically adjusts the retracted feed finger
position by the same amount. When adjusting the feed pitch, the terminal feed position over the anvil does not change.
Note 2: The terminal position will not change when reducing the terminal feed position over the anvil. To see where the terminal will be located
over the anvil, the terminal drag may be released and the strip retracted to contact the feed finger. Make sure to engage the terminal
drag after completing the feed adjustment.
Figure 34
Retract Feed
Finger Key
Extend Feed
Finger Key
Feed In Retracted Position/Pitch
Adjustment Indicator
Feed In Extended Position Feed
Adjustment Indicator
Feed Full-Cycle Key
Increase Feed/Pitch
Adjustment Key
Reduce Feed/Pitch
Adjustment Key
Downloaded From
