39
TCS 3000 Installation
www.tcsmeters.com
Total Control Systems
TCS 3000 Software Update Kit (TCS 300882)
Item
Qty
TCS P/N
USB FEM/Mini Male Cable
1
TCS 300787
TCS 3000 USB
1
TCS 300795
USB Thumb Drive with
communication LED
Mini USB Port
Male Mini USB to
Female USB
FIGURE 1
Installation Procedure — Software Update
Installation Procedure:
1.
Load new software upgrade to a USB thumb drive (Minimum 8G, Formatted FAT 32).
NOTE: The new software upgrade should be the ONLY file on the drive.
2.
Open the TCS 3000 register. On the front cover of the register, there are 2 mini
-
USB connections. Using a factory
supplied USB cable, attach the thumb drive to the USB port closest to the inside of the register. This port is the
highest on the circuit board of the two. See Figure 1.
3.
Plug the USB cable into the USB port, and then insert the USB thumb drive into the mating cable (see Figure 1).
4.
Under Advanced Functions, locate System Update and press ENTER.
5.
The screen will display System Update, press MODE to continue with the update.
6.
If the thumb drive is not recognized or there is a faulty cable, the display will respond with NO UPDATE DATA error
message.
7.
Once the file is recognized, you will be prompted to remove the media. Remove the USB and the register will re-
boot and begin the update process. This should take approximately 3 minutes.
