TCM FD35C9, Workshop Manual

Page: 21 / 291

1-13
<Grinding>
(1) Put the specified safety cover on the grinding wheel.
(2) The clearance between the workrest and the grinding wheel should be
less than 3 mm.
(3) Install a shield to prevent grinding powder from flying off.
(4) Make a dry run on the grinding wheel for at least 1 minute before
each use or for more than 3 minutes whenever the grinding wheel
is replaced with a new one. During the dry run, do not stand in line
with the grinding wheel direction of rotation; otherwise you could be
injured by flying pieces of wheel if it breaks.
(5) Make sure the sander switch is turned off before connecting the power
supply cable.
(6) Check the power tool cables for damage. Do not use any power tool
with a damaged cable.
(7) Make sure there are no flammable gas leaks or flammable articles
where grinding sparks will splash.
(8) Do not perform sanding with the sander switch locked.
(9) Wear safety glasses whenever you perform any sanding or grinding.
(10) Do not use the side of the grinding wheel.
<Drilling>
(1) When using a magnetic drill, remove any dust between the magnetic
base and the work.
(2) Install a power shut-off device, such as a power switch, in a position
where the worker can operate it without leaving his working position.
(3) Make sure the machine is turned off before cleaning, inspecting or
repairing the machine or cutter.
(4) Use a suitable brush to remove cuttings from the cutter, or apply
lubricant to the cutter.
(5) Do not wear cloth work gloves when using devices such as a drill
mounted grinder.
(6) Hold the work in a vise when machining it with a drill mounted
grinder.
<Painting>
(1) Observe the following precautions when painting:
· Designate an organic solvent manager and put his or her name
(including this job description) in a conspicuous position.
· Put up a sign stating “No fire. Do not enter within 5 m of the
painting work area”. Install a fire extinguisher in the work area.
· Use explosion-proof fans and lights in a narrow space or an
enclosed area.
· Provide a local ventilation system, where necessary.
· Do not bring more paint than necessary into the work area.
· Reinstall the cap on any paint container not being used.
· Wear a gas mask to prevent organic gas poisoning.
· Do not install any electrical switches inside the painting work area.
· Check the electrical system in the painting work area as necessary.
(2) Do not incinerate used spray cans. Make a hole in the can when
disposing of it.
COVER
SHIELD
VISE
3 mm
[0.118 in.]
WORKREST