TCM FD35C9, Workshop Manual

Page: 171 / 291

3-57
Fig. 3.188
Fig. 3.191
Fig. 3.189
⑤
Install the thrust washer (1) and bearing (2) on
the main shaft. Secure with the washer (3) and
snap ring (4).
⑥
Install the same number and thickness of
shims (1) and spacers (2) that you recorded
during removal, and secure with the snap ring
(3).
Shim thickness:
0.1, 0.2, 0.5 mm [0.004, 0.008, 0.020 in.]
Axial movement of shaft:
less than 0.2 mm [0.008 in.]
⑦
Apply LOCTITE#575 to the outer edge of the
cap and install the cap.
⑧
Install the support assembly using the spacer
and shims. Make sure that the oil seal (2) and
“O”-ring (3) are installed on the support (1).
Shim thickness: 0.1, 0.2, 0.5 mm
[0.004, 0.008, 0.020 in.]
19.6 N-m {2.0 kgf-m} [14.5 ft-lbs]
Fig. 3.190
Apply LOCTITE#575.