![background image](http://html1.mh-extra.com/html/tc-electronic/g-sharp/g-sharp_user-manual_3896914013.webp)
12
TYPICAL SETUPS
In this setup the G-Sharp is connected to
the effects loop of an amplifier.
• Connect guitar to drive pedals, wah etc. and
into the amps input.
• Connect the effect loop send to the left input
of the G-Sharp.
• Connect the G-Sharp left output to the return
of the amplifier.
• Set Routing to serial or parallel.
• Set Input level to 12 o’clock position.
• Set EFFECTS MIX to 12 o’clock position.
• Set REVERB MIX to 12 o’clock position.
• Adjust/fine-tune the G-Sharp Input level so
the Input LED on the front panel often is
yellow but only rarely peaks at Red color.
• Select Effects and Reverb type using the
selectors on the front panel.
• Now fine-tune EFFECTS and REVERB mix
as well as parameters.
The setup is mono but could be expanded to
stereo if the Right output of the G-Sharp is
connected to a separate amp.
Serial Setup