TC Electronic G-Sharp, User Manual

Page: 9 / 30

8
REAR PANEL
Balanced
Jack
Analog
Inputs Pedal
Input
MIDI
In/Out KILLDRY switch
Balanced
Jack
Analog
Outputs Digital
S/PDIF
Input/
Output
Power Input
100 - 240VAC
KILLDRY switch
With the switch in “in” position, no clean signal
passes through the G-Sharp. This is the setting
to use if you connect G-Sharp in a parallel loop
or e.g. in an aux send/return on a mixer.
Analog Input
Analog Input on 1/4 inch connectors.
Use Left Input only to connect a mono signal.
Analog Output
Analog output is a stereo output on two 1/4”
jack connectors.
Power In
G-Sharp has a switchmode power-supply that
accepts from 100 to 240VAC.
Pedal Input - for TC G-Switch
Two different modes can be set for the pedal
Input: With the TC Electronic G-Switch pedal
you are able to:
In mode A:
Switch 1 - Preset up
Switch 2 - Preset down
Switch 3 - G-Sharp bypass
In mode B:
Switch 1 - Bypass Effects Engine
Switch 2 - Bypass Reverb Engine
Switch 3 - Tap tempo
Selecting Modes
Press LOAD and PRESET ON/OFF at the
same time. Then use the ARROWS to select
between A and B.
TC G-Switch