16
OPERATING - INPUT/OUTPUT SECTION
INPUT GAIN & 1/L-2/R INPUT LEDs
This knob controls the input level for both the
analog and digital input options. A correctly set
input level is essential to achieve optimal
performance with least possible noise.
To set the Input level:
Clean sounds have the most dynamics. Play
powerful chords with the loudest clean sound
you use and adjust the Input Gain accordingly.
The Input LEDs indicate the level using three
colors.
Green
: -40dB - You are “well on the safe
side”.
Yellow
: -6dB - You are close to optimal
performance.
Red
: -1dB - Red LED only blink
occasionally at absolute peaks.
Analog Input Range
Counter-clockwise
: -10dB
Center
: 0dB
Clockwise
: +14dB
Digital Input Range
Counter-clockwise
: -18dB
Center
: 0dB
Clockwise
: +6dB
Parallel mode/(serial mode) LED and button
Press the switch to switch between Serial and
Parallel modes. When this LED is lit (green)
Parallel mode is selected. When the LED is not
lit - Serial mode is selected.
EFFECTS MIX
Adjusts the mix between the wet and the dry
signal for the Effects engine.
REVERB MIX
Adjusts the mix between the wet and the dry
signal for the Reverb engine.
BYPASS LED
When the LED is lit, G-Sharp is in bypass
mode. The bypass function operates differently
depending on whether you are in Killdry mode
or not.
Killdry “on”:
The BYPASS key operates as a mute function.
Killdry “off”:
The bypass function simply passes the source
signal unprocessed to output.
Killdry ON LED
Killdry mode is selected on the rear panel.
When it is selected, no clean signal passes
through the G-Sharp. This is the setting to use
if you connect G-Sharp in a parallel loop or e.g.
in an aux send/return on a mixer.
