TC Electronic G-Major, User Manual

Page: 34 / 52

32
FLANGER
Classic Flanger
- CHO/FLA Block
Speed
Range: 0.050Hz to 19.95Hz
The speed of the Flanger, also known as Rate.
The speed of this effect block is either
defined by this parameter or by the
Tempo parameter which sets the speed
according to the globally tapped tempo.
This Speed parameter is only
active/valid if the Tempo parameter is
set to “Ignored”.
Depth
Range: 0 to 100%
Adjusts the Depth of the Flanger, also known
as Intensity. The value represents the amount
of modulation applied.
Tempo
Range: 1/32T to 1 Bar or Ignored
The Tempo parameter sets the relationship to
the global Tempo.
When set to anything else than Ignored
the tempo defined by the Speed
parameter is ignored.
Hi Cut
Range: 19.95Hz to 20kHz
Reduces the high-end frequencies in the
Flange effect. Try using the Hi Cut parameter
as an option if you feel the Flange effect is too
dominant in your sound and turning down the
Mix or Out level doesn’t give you the dampening
of the Flange effect you are looking for.
Feedback
Range: -100 to 100
Controls the amount of Feedback/Resonance
of the short modulated Delay that causes the
Flange effect. A too high Feedback setting
(above approx. 90-95%) might introduce an
actual internal Feedback resulting in a
squealing noise that in most cases is unwanted
in flanging effects. Be aware of this when
experimenting at high
volumes. Setting this parameter to “-100”
reverses the phase of the signal that is fed
back to the algorithm Input.
FB Hi Cut
Range: 19.95Hz to 20kHz
A parameter that can attenuate the high-end
frequencies of the resonance created via the
Feedback parameter.
Mix
Range: 0 to 100%
Sets the relationship between the dry signal
and the applied effect in this block.
Out level
Range: -100 to 0dB
Sets the overall Output level of this block.
Advanced Flanger
- CHO/FLA Block
Speed
Range: 0.050Hz to 19.95Hz
The speed of the Flanger, also known as Rate.
The speed of this effect block is either
defined by this parameter or by the
Tempo parameter which sets the speed
according to the globally tapped tempo.
This Speed parameter is only
active/valid if the Tempo parameter is
set to “Ignored”.
Depth
Range: 0 to 100%
Adjusts the Depth of the Flanger, also known
as Intensity.
Tempo
Range: 1/32T to 1 Bar or Ignored
The Tempo parameter sets the relationship to
the global Tempo.
When set to anything else than Ignored
the tempo defined by the Speed
parameter is ignored.
Hi Cut
Range: 19.95Hz to 20kHz
Will reduce high-end frequencies in the Flange
effect. Try using the Hi Cut parameter as an
option if you feel the Flange effect is too
dominant in your sound and turning down the
Mix or Out level doesn’t give you the dampening
of the Flange effect you are looking for.