TC Electronic G-Major, User Manual

Page: 18 / 52

16
MIDI/UTIL
the pedal is pressed. Alternating pedal types
“stays connected” when pressed, and must be
pressed again to be deactivated. Default setting
is Expression.
Pedal Calibrate
For the G•Major to respond correctly to the
actions performed by a connected Expression
pedal, the G•Major must be calibrated to the
specific pedal.
• Connect your pedal and select appropriate
pedal type.
• Select Pedal calibrate and press ENTER.
• Move pedal to Max position (heel up) and
press ENTER.
• Move pedal to Min position (heel down) and
press ENTER.
• Your pedal has been calibrated.
Depending on the pedal type you are
using you can be asked to repeat steps
3 and 4.
Tuner Ref.
Range: 420 to 460Hz
Sets the master Tune frequency of the built in
Tuner. 440Hz is the standard setting.
Tuner Mode
The Tuner can operate with two different
accuracies.
Fine Tune
Maximum accuracy. Use this mode when fine-
tuning your guitar.
Coarse
Slightly less accurate mode, allowing for fast
results in a live situation.
Tuner Range
Sets the range of the Tuner. Select between
Bass, 7-string Guitar and Guitar. The accuracy
of the Tuner is dependent on this tuner range,
and it is therefore important to set this
parameter according to the instrument you
desire to tune.
Send Tuner
Set this parameter to “On” to feed a connected
G•Minor with Tuner information.
MOD Master
Range: Read/Ignore
If you are not acquainted with Modifiers you
can read about them in the Modifier Section of
this manual. In short - parameter values can be
controlled via an external controller such as
e.g. a MIDI Expression pedal. If setup to control
e.g. the Preset Out Level you must decide via
this MOD Master parameter how you would like
the G•Major to respond to the position of the
Expression pedal at preset changes. Choosing
between the following options depends very
much on what your Modifier is set up to
do/control.
Mod
If set to “Mod” the G•Major will at any preset
change check the position of the connected
external Controller and respond to this position
thereby ignoring the Modifier value for the
relevant parameter.
Preset
If set to “Preset” the G•Major will ignore the
position of the connected External controller
and load the Modifier value stored with the
preset.
If using Ignore function with an
Expression Pedal that is controlling a
level parameter, you should be aware
that next time you move the pedal the
parameter will jump to the value
equivalent to the pedal position. This
could in some cases mean a
considerable jump in level.
Tap Master
Preset : Tempo will follow presets.
Tap : Tempo will follow the Global tapped
tempo.
Tap Unit
Selects whether the tapped tempo in the Tap
Menu should be displayed in milliseconds (ms)
or in Beats Pr Minute (BPM).
MIDI Clock
Range: On/Off
The Global Tap Tempo can be synchronized to
an Incoming MIDI clock from e.g. a MIDI
sequencer.
Thereby you can e.g. keep a Delay Time in
sync with the Tempo of the song.