Installation
Mounting on your frame
The TBS POWERCUBE should be placed in the same
spot where the flight controller is normally installed.
The TBS POWERCUBE carries power (VBatt, GND) over
the four standoffs in the corners, alternating between
VBatt and GND. For this reason, the two screws
carrying power (VBatt) are hidden underneath the
double sided sticky tape on the bottom of the TBS
POWERCUBE. The tape isolates them from the carbon
fiber frame. The ground-carrying standoffs should be
used to bolt the TBS POWERCUBE onto the frame. In
combination with the tape, this creates a very solid
mount.
The corners on the top layer indicates the polarity of the power, i.e. “+” for VBatt and “-” for GND, as shown in
the image below.
8
