TBB Energier Pro Series, User Manual, Page: 32 / 56

Energier pro User Manual
26
Using DIP Switch 1, you can set the system in weak grid mode. Please refer to chapter 2.9 for explanation.
The default setting was OFF, 10.5 VDC (12 V model) / 21VDC (24 V model) / 42 VDC (48 V model).
Through DIP Switch 2, you could configure the system in solar mode. For explanation, please refer to chapter 2.10.
4.2 Weak Grid mode
4.3 SOLAR mode
Through the DIP Switch 3, you can configure the premium low voltage protection level for your system. Following please find
following the data.
The following DOD is ONLY estimation. The exact measure of the battery SOC is almost impossible with only electrical parameter.
It may vary according to discharge current, battery healthy etc.
4.4 Low Voltage disconnect (LVD)
Please refer to following chart for all setting of DIP Switch:
DIP Switch
1 2 3
Weak Grid Mode Solar Mode LVD
6 5
EQ
7
P.S.
8
GEN Mode
4
Battery Type
This configuration will adjust the minimum voltage of AC input which Energier pro bi-directional inverter will qualify
and pass through to your AC appliance. Majority of present appliance will work properly. However, before perform
this configuration, please double check the electrical rating of connected load. Low voltage might cause damage for
particular load.
DS3 12 VDC model 24 VDC model 48 VDC model
off
on 11.7 VDC 23.4 VDC 46.8 VDC ab. 60% solar or backup
10.5 VDC 21.0 VDC 42.0 VDC
est DOD
>90%
recommendation
mobile