Seite 29 von 45
Use of the “PowerPort”
The “PowerPort” provides amplified signals to drive special accessories, like a flat
magnetic coil adapter, or a special lamp adapter with an array of UV-LEDs.
See options for details.
“DATA EXCHANGE” between
F-SCAN2
and SATELLITES
If the ‘SETUP window 2’ is displayed, two different command lines can be touched to send
the content of the operating memory via a special data cable to an F-SCAN or an
F-SCAN2 SATELLITE.
The command line “Transfer to SAT 1” transfers the data set to an F-SCAN.
The command line “Transfer to SAT 2” transfers the data set to an F-SCAN2 SATELLITE.
OPTIONS
The special software
F-SCAN developed by TB-ELECTRONICS
The unit can be connected to a PC or Notebook – or to a serial printer - with the special
data cable and remotely controlled from the computer if the software F-SCAN is loaded
and active. This feature allows – among all other tasks – to establish a data bank with
patients data.
Contact your dealer or the factory for detailed information.
BATTERY PACK
A small but powerful battery pack supports uninterrupted applications of frequencies
independent from an outlet for up to 3 hours with a fully charged battery. The 7.2 Volt
lithium – ion battery can be recharged at least 1000 times if treated and stored correctly.
The battery pack assembly contains all components required to charge, use and control
the battery. A specially designed mechanism allows the user to replace the battery at the
end of it’s life without tools. The housing is equipped with anti-slide supports. The
assembly plugs into the power connector and fit’s between the legs of the Frequency
Synthesizer if they are extended.
FLAT MAGNETIC COIL ASSEMBLY
The special round and flat magnetic coil generates a weak magnetic field which can be
used to carry frequency signals into deeper regions of the body. The coil is attached to the
device with 2mm “pin” cables. It’s operating bandwidth is 1MHz. For further information
see the manual shipped with the coil.
ADAPTER FOR FREQUENCY-MODULATED UV-LIGHT
This tube-shaped adapter has an array of LED’s emitting ultraviolet light. UV-light
penetrates the skin deeper than the full spectrum light. It can be used parallel to pad
electrodes or for stand alone applications. The adapter connects to the POWER PORT.
(Eyes must be protected from UV-Light during application!) For further information see the
manual shipped with the adapter.
