Seite 26 von 45
The DIRP analysis stops at the upper frequency limit of 560,000Hz.
Remove the finger electrode
and rest the handheld electrode until ready to start an
application. It is important to select the correct wave form for the therapy. Touch THERA
now, select the wave form and go back to DIRP.
The horizontal line can now be raised or lowered with the arrow buttons to a
C
lipping
L
evel. All resonant values touching or exceeding the horizontal line can be transferred to
the operating memory with a touch on the icon “TRANS”.
If window 2 of the tab SETUP is displayed, and a serial printer attached to the RS232
connector of the device, the DIRP data set can be printed and/or the DIRP graph and/or
the content of the operating memory and/or the SETUP window 1.
NOTE: If the number of selected frequencies exceeds 50, the message MEMO FULL
appears in the bottom line indicating that no more values can be accepted.
Continued on next page!
The frequency currently sent to the user via the
handheld electrode is displayed in the frequency
field.
All answers from the user (
MV
) are briefly shown
in the bottom line and entered into the graph.
The conductivity value (
CV
) is shown under the
graph (meaningful only for frequencies above
100Hz) as well as the distance of the horizontal
line from the x-axis (the
C
lipping
L
evel).
6 resonant values were transferred from the
sample run shown. The last is shown here.
The user can page through the memory
positions with the buttons “PREV” and “NEXT”
and, if required, eliminate entries with a touch on
“MCLR” in any memory position with a value.
The “
S
weep
T
o
N
ext”-feature can be activated
for any two adjacent frequencies in the list.
If window 1 of the tab SETUP is displayed, the
“50 TIMER” feature, “PULSE” or “WOBBLE” can
be activated as well.
Touch the tab DIRP to display the window.
Place the handheld electrode on the red lead
into the left hand of the user.
Instruct them to
hold their right hand still.
Touch “GO” to start the DIRP analysis.
