4
Introduction
Model SB25
SB25 Specifications
The Model SB25 is a combination unit consisting of
the Model SB24 commercial ice shaver/blender unit
and a rinse station.
The Model SB24 shaver/blender unit has the option
of metered water and liquid sugar cane dispensing.
The rinse station is a timer controlled, automatic
system that rinses the interior of the blender
pitchers.
Ice Hopper
The standard frosted ice hopper holds approximately
28 lbs (13 kg) of ice. An optional clear ice hopper is
available which holds approximately 15 lbs (7 kg) of
ice.
Blender Pitcher
The maximum fill capacity of the blender pitcher is
48 fl oz (1.4 liters).
Electrical
Two dedicated electrical connection are required for
the SB24 and X81173-12. See the electrical chart
for proper electrical requirements. Manufactured to
be cord connected. Cord length is 9 ft. (274 mm)
external to unit.
Blender Station
Electrical
Total Amps
Supplied with
NEMA Cord
115/60/1
10.0A
5-15P
Rinse Station
Electrical
Total Amps
Power Supply
24 VAC
0.63A
115V
This unit may be manufactured with other electrical
characteristics. Refer to the local Taylor Distributor
for availability. (For exact electrical information,
always refer to the data label of the unit.)
Water
A 3/8” (9.5 mm) water line with minimum 55 PSI
(380 kPa) is required.
INSTALL POTABLE WATER CONNECTION
WITH ADEQUATE BACK-FLOW
PROTECTION TO COMPLY WITH
APPLICABLE NATIONAL, STATE AND
LOCAL CODES. WATER TEMPERATURE IS
NOT TO EXCEED 125°F (51°C).
Drain
A drain is required. The drain must be able to
accommodate a 1-1/8” (29 mm) diameter drain tube.
A minimum of 1” (25 mm) air gap is required
between the end of the drain tube and the drain to
ensure proper flow.
IMPORTANT:
The unit must be installed on a level
surface for proper drainage.
Accessories include 10 ft. (3050 mm) of 7/8” (222
mm) ID drain hose.
Air Cooled
No additional clearance is required on either side of
the unit for air inlet or discharge.
2” (50 mm) of clearance is required behind the unit
to allow for proper routing of the drainage hardware.
12” (304 mm) of air clearance is required above the
unit to allow for proper loading of ice into the ice
hopper.
Dimensions
Width:
12-1/4” (311 mm)
Depth:
18” (457 mm)
Height:
23-1/2” (597 mm)
Approximate Weights
Net:
35 lb (15.9 kgs)
Crated:
Carton #1 35 lbs. (15.9 kgs)
Carton #2 11 lbs. (5 kgs)
Water Pressure
55 PSI (380 kPa) minimum incoming
100 PSI (690 kPa) maximum incoming
