26
Controls and Systems
Model SB25
On-Off/Reset Switch
______________________________
The On-Off/Reset switch provides power to the unit
and is also used to reset the Drive Board in the
event of a shaver or blender motor lock.
Troubleshooting
If there is no power to the unit check the following:
1.
Check outlet
2.
Check power cord at outlet
3.
Toggle switch
4.
Drive board and dispense board fuses
5.
Check connection at the switch to the harness.
Figure 31
Replacement
Step 1
Disconnect the power cord from the outlet.
Step 2
Press the toggle switch snap-in feature to remove
the panel (keep wires connected).
Step 3
Using a pair of needle nose pliers, remove the wire
connectors, one at a time, and reconnect to the new
switch.
Step 4
Remount the switch into the panel.
Figure 32
Drain System
______________________________
The shaver/blender drain system consists of a
series of hoses. There is one interior hose and one
exterior hose that connect to an exterior drip pan.
These must be kept clean to maintain water flow.
The exterior hose must be running downhill, with no
kinks.
Note:
This is not required when the shaver unit is
being used with the rinse station. When using the
rinse station, the drain pan should be removed.
Troubleshooting
If the drain lines are not kept clean, a build-up of
algae will occur. This will block the water flow and
cause back-up and possible leaks. The use of a
cleaner will prevent this problem. To clean clogged
drain lines, use a small wire bottle brush available
from your Taylor Distributor. To check for leaks,
pour water into the top and bottom drain holes.
Note:
To remove the drain hose from its
connection, if necessary, cut the hose with a razor
blade. This will allow for easy removal.
