27
Model SB25
Controls and Systems
Blender Pitcher
______________________________
The blender pitcher was designed with no
replaceable wear items and will only sit on the
blender base in one position. (
Note:
Never wash the
blender pitcher in the dishwasher.)
Safety Switch
______________________________
The purpose of the safety switch is to interrupt
power to the unit when the cover is removed. If the
safety switch is not performing this function, check
that the white safety switch rod located in the rear
left hand corner of the ice hopper is in place.
Check to see if the magnet located in the rear left
hand corner of the hopper cover which engages the
safety switch rod is in place. Replace the ice hopper
or the ice hopper cover if either component is
missing.
Correct Cover Placement
Figure 33
Incorrect Cover Placement
Figure 34
Water Dispense
______________________________
The water dispense supplies water to the blender
pitcher during drink dispensing.
Troubleshooting
If water is not dispensed or an incorrect amount is
dispensed, check the following:
Step 1
Make sure the water line is connected to the rear of
the system and is free from kinks.
Step 2
Make sure that adequate water pressure is being
supplied to the system.
Step 3
Make sure the water filtration is working properly.
Step 4
Check the system for leaks.
Disassembly
Step 1
Turn off the power switch and unplug the
power cord.
Step 2
Remove the ice hopper and lid. (See page 17.)
Step 3
Remove the main drain assembly. (See page 19).
Step 4
Remove the Dispense PCB cover.
