Taylor K-8000, User Manual, Page: 97 / 100

8-3 TTi
®
Colorimeter User’s Manual
Part 8 Compliance Synopsis
CERTIFICATION
The TTi
®
Colorimeter Series is certified to the following instrumentation Directives and Standards:
• Directive 2004/108/EC, Electromagnetic Compatibility Directive
• Directive 2006/95/EC, Low Voltage Directive
• FCC, Radio Frequency Devices, Unintentional Radiators, 47 CFR Part 15, Subpart B
• UL 61010-1 - Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory
Use - Part 1: General Requirements
• ICES-003 - Issue 4 February 2004 - Spectrum Management and Telecommunications Policy -
Interference-Causing Equipment Standard - Digital Apparatus
• CSA C22.2 No. 61010-1 - Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use - Part 1: General Requirements
• EN 61326-1:2006 - Electrical Equipment for Measurement, Control and Laboratory Use -
EMC Requirements – Part 1: General Requirements
• EN 61010-1:2001 - Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use - Part 1: General Requirements
• IEC 61010-1 - Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory
Use - Part 1: General Requirements
INFORMATION TO THE USER
The user is cautioned that if the instrument is used in a manner not specified by Taylor Technologies, Inc., the
protection provided by the instrument may be impaired.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
The user is cautioned that changes or modifications not expressly approved by Taylor Technologies, Inc., could
void the user’s authority to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help