Taylor 432, Operator'S Manual

Page: 27 / 42

OPERATING PROCEDURES
6-7
Model 432
Operating Procedures
6
4. Place the mix hopper cover in position. Periodically,
during the day’s operation, check to be sure there is
a sufficient amount of mix in the hopper.
Figure 6-25
5. Repeat steps 1 through 4 for the other side of the
machine.
Closing Procedure
To disassemble this machine, the following items will be
needed:
• Two cleaning pails
• Necessary brushes (provided with freezer)
• Cleaner
• Single-service towels
Draining Product from the Freezing
Cylinder
1. Place the control switch in the OFF position as far
ahead of cleaning time as possible to allow frozen
product to soften for easier cleaning.
2. Raise the hopper cover. If the machine is equipped
with an air/mix feed tube, take it to the sink for
cleaning.
3. If local health codes permit the use of rerun, place
a sanitized, NSF-approved stainless steel rerun
container beneath the door spout. Place the control
switch in the WASH position and move the draw
handle to the right. When all the product stops
flowing from the door spout, move the draw handle to
the left and place the control switch in the OFF
position. Place the sanitized lid on the rerun
container and place it in the walk-in cooler.
Note: If local health codes do not permit the use of
rerun, the product must be discarded. Follow the
instructions in the previous step, except drain the product
into a pail and properly discard the mix.
!
ALWAYS FOLLOW LOCAL HEALTH CODES.
4. Repeat steps 1 through 3 for the other side of the
machine.
Rinsing
1. Pour 2 gal. (7.6 L) of cool, clean water into the mix
hopper. With the brushes provided, scrub the mix
hopper and the mix inlet hole.
Figure 6-26
2. With a pail beneath the door spout, place the control
switch in the WASH position and move the draw
handle to the right. Drain all the rinse water from the
freezing cylinder. When the rinse water stops flowing
from the door spout, move the draw handle to the left
and place the control switch in the OFF position.
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.
3. Repeat steps 1 and 2 for the other side of the
machine.