6-4
OPERATING PROCEDURES
Model 432
Operating Procedures
6
13. Place the large rubber gasket into the groove on the
back side of the freezer door. Slide the white, plastic
front bearing onto the bearing hub, making certain
that the flanged end of the bearing is resting against
the freezer door.
Do not
lubricate the door gasket or
front bearing.
Figure
6-13
14. Install the door on the four studs on the front of the
freezing cylinder. Install the four handscrews on the
door, and tighten them equally in a crisscross
manner.
Figure
6-14
15. Position the torque arm by inserting it through the slot
in the torque switch arm and down into the hole in the
torque rotor which protrudes from the door. Verify
proper installation by moving the torque rotor back
and forth to be sure it moves freely and easily.
Figure
6-15
16. Install the front drip pans. Slide the long drip pans
into the holes in the front panel.
Figure
6-16
101616
101651
101652
101653
Summary of Contents for 432
