Taylor 432, Operator'S Manual

Page: 19 / 42

Section 5
5-1
Model 432
User Interface
5
User Interface
Figure 5-1
The following chart identifies the symbol definitions used
on the operator switches.
= ON/AUTO button
= OFF button
= WASH button
Control Switch
The center position is OFF. The left position is WASH,
which activates only the beater motor. The right position
is AUTO, which activates the beater motor and the
refrigeration system.
Push-Button Switch
If an overload condition occurs, the freezer will
automatically stop operating. To properly reset the
freezer, place the control switch in the OFF position. Wait
two to three minutes; then press the push-button switch.
Place the control switch in the WASH position and
observe the freezer’s performance. Place the control
switch in the AUTO position.
Note: If the freezer is unplugged from the wall
receptacle, it will be necessary to press the push-button
switch for the freezer to operate once power is
reestablished.
Display Light Switch
The display light switch is located under the control
channel. The left position is OFF. The right position is
ON, and activates the display light.
4
1
2
3
5
6
Item Description
1 Control Switch- 3 PDT
2 Push-Button Switch- SPST
3 Display Light Switch- SPST - 3/4 HP/250 V
4 Light- Amber- Rect. - 12 VDC - MIX OUT
5 Light- Amber- Rect. - 12 VDC - ADD MIX
6 Viscosity Adjustment