background image

Moist SURE

 Automated Dispenser 

REF 95762

INSTALLING DISPENSER ON WALLPLATE

Dispenser is shipped 
with the center screw 
attached (shaded). 
This tab must be 
removed when 
dispenser is installed 
on wallplate.

1

1a

1b

To install on 
wallplate, open 
dispenser as 
shown.

2

Wallplate

Dispensing
Volume

Place dispenser 
over 4 latches at 
bottom of wallplate.

3

Push down 
with thumb, 
making sure 
tabs lock below 
reinforcing bar.

4

REMOVING DISPENSER 
FROM WALLPLATE
To remove dispenser, 
pry out tabs to clear 
plastic reinforcement ribs 
on wallplate. Then slide 
dispenser up and pull off 
of wallplate.

INSTALLING AND REPLACING BOTTLE

To open dispenser, 
press down on top to 
release side latches. 
Dispenser cover will fall 
open. If dispenser does 
not open, slightly rock 
dispenser side to side 
while pressing down.

1

Set new bottle into 
position and make 
sure cap is seated 
 properly in cap 
retainer. 

4

View of 
dispenser 
side latches.

1a

Close up of 
dispenser cover 
side latch.

1b

Rear View

Side View

Open dispenser.

2

Snap off 
and discard 
protective 
cover from 
new bottle.

3

Remove blue 
vent plug.
  
Close cover.

5

6

6a

Make sure 
bottle tip 
is properly 
inserted into 
center of hole. 

7

Dispenser 
is now 
ready to 
use. 

LOW BATTERY WARNING

The graphic on the front of the  
dispenser will blink for 48 hours  
when the batteries are low.  
This indicates it is time to  
change the batteries.

Requires 4 AA Alkaline Batteries
Open battery cases by unscrewing 
counterclockwise and squeezing latch to pull 
open. Spring end is negative (-) end of battery.

+

+

Battery Compartments

T652-INC(914)             62179

1 of 2

T652-INB
7/6/12  11:12am Rev8

SETTING DISPENSING VOLUME

The unit has three dispenser settings.

1)   On the backside near the bottom  
 

of the unit is a recessed switch to  

 

control dispensed amounts.

2)   When facing unit on the wall: 
 

a. Setting to far left: 

Low 

 

b. Setting to center: 

Medium 

 

c. Setting to far right: 

High

3)   Move switch to desired dispense setting.

Note: As a guideline the approximate volumes are 
Low = 1.0mL Moist SURE Liquid Sanitizer, 
Medium = 1.5 mL Moist SURE Hand Soap, 
High = 2.0 mL. 
Settings can be adjusted per user preference.

1c

Reviews: