Version 1.03
33
It is advisable to connect the bottle explosive capsule and tightly screw the retention ring before installing the
bottle in the vehicle in case the room around the bottle does not allow easy access to the connector when
installed.
WARNING
If the bottle is connected with the Control Unit switch in the ON position, the system might go on. Always make
sure that the bottle connector is tightly screwed before setting the Control Unit Lever Switch to On.
With the switch still in the OFF position, press one of the two buttons and check that the LED turns on, thus
indicating that the system is connected correctly.
N.B.: the LED verifies the functionality of the system and turns on ONLY when the extinguisher valve is
connected to the system. If the LED does not turn on after having connected the system, check the connections
and/or try replacing the battery.
If you have checked the connections and installed a new 9V battery and the LED still does not turn on, contact
your local dealer.
If the LED turns and correctly with the lever in the OFF position, your system is ready to be put into operation
by moving the switch to the ON position.
WARNING
It is recommended that you replace the electrical control unit 9V battery before every race.
2.12.5
Technical specifications
System:
Bottle operating pressure:
16,5 Bar
Minimum pressure:
12 Bar
Maximum pressure:
18 Bar
Battery power:
9V alkaline battery
Electrical valve igniter:
9V non-polarized
Liquid extinguisher:
Name:
Sabolite
Usage temperature:
- 15°C / + 60°C
Appearance:
red liquid
Density at 20° C:
1.07 Kg/dm3
PH:
7 ±I
Boiling point:
-100°C
Biodegradability:
rapidly biodegradable RO.D. 220'000 mg02/1
Chemical Comp.
aqueous solution containing hydrocarbon surfactants, fluorosurfactants,
and antifreeze agents
Ecotoxicity
rapidly biodegradable
Hazardous components
ethylene glycol, urea
2.12.6
Maintenance
Before every race:
Check that the pressure gauge needle is inside the green area on the scale. If the needle is not inside the
green area, have the system recharged. Check that the tamper-proof seal is whole and intact. If the tamper-
proof seal has been compromised, have the system checked and replaced if necessary. Replace the 9V battery
that powers the system's electrical control. Put the system's electrical control unit lever switch in the OFF
position and make sure that the LED on the control unit turns on, both when you push the system activation
button located on the control unit, and when you push the external button located near the bottom of the
windshield. If the LED does not turn on when you push either of the control buttons, check the electrical
connections and or replace the control unit battery and repeat this check. If the LED remains off, contact
technical support.
Before the race, put the lever switch in the ON position.
WARNING
When the control box lever switch is in the OFF position, the extinguishing system is disabled. Check that the
Summary of Contents for GB3 CHAMPIONSHIP
