Tatung TDR-22 Series, Installation And Operation Manual

Page: 22 / 64

TATUNG TDR series Digital Recording System Page
18
3.5 Motion
This function button (as shown below) can be used to setup the motions.
1. Select channel
Select a channel (from 1 to 16).
2. Set up motion detection zone.
Setup the motion detection zone for each channel by clicking and draging. It will
be designated by a red square (Maximum 10 areas per camera).
3. Set up the MISC options.
Motion beep
In motion recording mode, BEEP sound (if the speaker was included in the
system) can be activated/deactivated by checking the box or not. Beep time can
be also be adjusted by dragging the cursor accordingly.
Click on this button to setup the motion, the screen display as the below
(Please following the 4 steps)
Note: If no detection zone is
defined, the system will
recognize the whole windows
as the detection zone.
Note: After the camera is
motion activated in Schedule
Setup Mode and after the
detect zone is set, this
channel will be motion-
activated in the defined area.
If anything falls in this area,
the detected motion will be
seen in a lot of small blue
squares. And red wording
“MOTION DETECTION” will
be blinking.