Tatung TDR-22 Series, Installation And Operation Manual

Page: 20 / 64

TATUNG TDR series Digital Recording System Page
16
MISC
Check on the box if you want the following features to be enabled.
Image Quality
Dragging the cursor can adjust the compression rate, the higher the compression the
worse the image quality. The recorded image with best quality (100%) is clear and
vivid. But the size of a frame is the largest (15KB-20KB). At lower percentage of
quality (higher compression rate) image quality is relatively low. But the size of a
frame is relatively small (2KB-8KB). 34%-50% of image quality is recommended.
Frame Size**
Compression Rate Image Quality
Range Average
0% 2400-7200 byte 5.0 KB
10% 2600-8100 byte 5.5KB
20% 2900-9300 byte 6.0 KB
30% 3500-10300 byte 7.0 KB
40% 4100-12000 byte 8.0 KB
50% 5000-14000 byte 9.5 KB
60% 6000-16000 byte 11.0 KB
70% 6600-17000 byte 12.0 KB
80% 8200-20000 byte 14.0 KB
90% 9200-22000 byte 16.0 KB
HIGH
LOW
100% 14000-24000 byte 19.0 KB
* Frame size may vary from image to image according to the situation of site
EXIT
You may click any other icon to exit Speed Setup Mode and go directly into other
setup mode. Click EXIT button to go back to Watch Mode.
Sensor Beep Activates beeping sound when sensor is triggered.
Proportion
When activated, only 1, 4, 9, & 16 divisions are available to
keep the horizontal and vertical ratio of each channel window.
Motion Log Activates Motion log function.
Recording While
Searching
Continues to record when the system in search mode.
Removable HDD System Will BEEP when the removable HDD is almost full.
Pre-Alarm Set up PRE-ALARM and PRE -MOTION in SECONDS
Note: When complete the
setup and exit to the LIVE
mode, the system will
spend about 20 second to
compensate and install
the new setting. This
operation may cause the
image of the cameras
stop motion or
discontinuous motion.
The recorded data also
have the same effect.