©Copyright Task Force Tips, Inc. 2008-2014
LIY-500 May 12, 2014 Rev10
19
4.4.3 ELECTRICAL WIRING
See fi gure 4.0 for typical connections. The 4-conductor cable from the receptacle needs to be connected to power (red & black) and
to the communication link (blue & white) from the monitor. Refer to Figure 4.2.2 for typical cable preparation.
4.4.4 OPERATION
This operator station is tethered to the truck with a 10 foot (3 meter), 30 foot (9 meter), or 100 foot (30 meter) cable. It is used to
move slightly away from the truck to get a better view for redirecting the monitor. This operator station gives the user full control of
the monitor including the PARK, OSCILLATE, and any AUXILIARY functions.
OSCILLATE button used to
initiate monitor movement
through stored sequence
(pattern) or to program a
sequence (pattern).
Read manual before use.
WARNING
800-348-2686
Y5700
FLASHING = LOW BATT
®
ON
FLOW
OFF
OSCILLATE
PARK
UP
MONITOR
DOWN
www.tft.com
POWER
NO COMMUNICATION LINK
WHEN ALTERNATING
P
PARK button used to initiate
monitor storage sequence
or to program storage
movements.
FOG button used to move
nozzle pattern to wide and
short reach.
STRAIGHT STREAM button
used to move nozzle pattern
to narrow and long reach.
LEFT button used to rotate
(sweep) water stream from
right to left from starting
point.
UP button used to move
water stream vertically up
from starting point.
DOWN button used
to move water stream
vertically down from
starting point.
RIGHT button used to rotate
(sweep) water stream from
left to right from starting
position.
MONITOR UP/DOWN
button typically used to
control RC Extend-A-Gun.
Also known as the AUX1
button. Could also be used
with YE-REMAUX relay
interface box to control
other devices.
FLOW ON/OFF button
typically used to control
RC Valve Kit or VUM. Also
known as the AUX2 button.
Could also be used with YE-
REMAUX relay interface box
to control other devices.
Fig. 4.4.4
Operator Station Control Pad
