©Copyright Task Force Tips, Inc. 2008-2014
LIY-500 May 12, 2014 Rev10
23
4.6 WIRELESS
OPERATOR STATION
The YE-RF-## Wireless Operator Station is supplied with a radio board that needs to be installed in the monitor control box and a
storage bracket.
4.6.1 MOUNTING STORAGE BRACKET
The storage bracket is supplied with (3) 1/4-20 stainless steel self-tapping screws. Make sure the material beneath the bracket is
substantial and thick enough to hold self-tapping screws. Make sure the area on the backside of the mounting surface is clear of
obstructions. We recommend a minimum thickness of 3/32” (.093” - 2.4 mm) in aluminum and 5/64 (.078”-2mm) in steel. See the
chart in Figure 4.6.1 to determine the correct pilot hole size.
Select proper location for mounting storage bracket. Panel space required will be 6.0“ x 11.2“ (152 x 285mm). Refer to Figure 4.6.1
for hole dimensions. Bracket can be used as a template. Be sure spring is in position.
Material
Hole Size
Use
Material
Hole Size
Use
Thickness
Inches
mm
Drill
Thickness Inches
mm
Drill
5/64-3/32
.206
5.2
#5
3/32
.213
5.4
#3
1/8
.213
5.4
#3
1/8
.221
5.6
#2
3/16
.221
5.6
#2
3/16
.228
5.8
#1
ALUMINUM
STEEL
Hole Size Chart For Self Tapping Screws
5"
[127mm]
6"
[152mm]
Drill (3) Pilot Holes
(refer to hole size chart)
Mount Bracket with (3)
1/4-20 Self-Tapping Screws.
Tighten Securely.
Spring
Fig 4.6.1 Wireless Operator Station
Storage Bracket Hole Dimensions
4.6.2 INSTALLING RADIO/ANTENNA
Turn off power and remove lid from monitor control box. Be careful to
open lid slowly as lid will be connected to the communication board by a
fl at cable.
ANTENNA
(for 2.4 GHz)
1) Ensure power is OFF to the unit.
2) Remove hex plug (if installed) from top of control box.
3) Install antenna fi tting with Red Loc-tite® into threaded hole.
RADIO
1) Unplug connector with blue & white wires and remove the small
communication board on the far left.
2) Attach antenna connector to radio board with the cable in the orientation
shown in Fig 4.6.2a.
Note: In some RC monitors, cable tie may need to
be cut to attach antenna.
3) Plug radio board into communication board. (Fig 4.6.2b) Be careful to
line up pins.
4) Plug communication board/radio board into main board. Press down to
seat securely.
5) Insert connector with blue & white wires into communication board.
Replace lid onto box. Be sure to guide fl at cable down onto motor boards
and to not pinch any wires between lid and box.
Tighten lid screws equally in a criss-cross pattern.
Fig 4.6.2a
Fig 4.6.2b
