©Copyright Task Force Tips, Inc. 2008-2014
LIY-500 May 12, 2014 Rev10
20
4.5 TETHERED OPERATOR
STATION WITH DISPLAY
(Y4E-CT-##-D
This operator station will have a factory installed 4-conductor cable, which will act as a tether, with a plug on the end. The installer
will need to mount the storage bracket and receptacle.
4.5.1 MOUNTING STORAGE BRACKET
The storage bracket is supplied with (3) 1/4-20 stainless steel self-tapping screws. Make sure the material beneath the bracket is
substantial and thick enough to hold self-tapping screws. Make sure the area on the backside of the mounting surface is clear of
obstructions. We recommend a minimum thickness of 3/32” (.093” - 2.4 mm) in aluminum and 5/64 (.078”-2mm) in steel See the chart
in Figure 4.5.1 to determine the correct pilot hole size.
Select proper location for mounting storage bracket. Panel space required will be 6.0“ x 11.2“ (152mm x 285mm). Refer to Figure
4.5.1 for hole dimensions. Bracket can be used as a template. Be sure spring is in position.
Material
Use
Material
Use
Thickness
Drill
Thickness
Drill
5/64-3/32
.206
5.2
#5
3/32
.213
5.4
#3
1/8
.213
5.4
#3
1/8
.221
5.6
#2
3/16
.221
5.6
#2
3/16
.228
5.8
#1
Inches
mm
Inches mm
ALUMINUM
STEEL
Hole Size Chart For Self Tapping Screws
Hole Size
Hole Size
5"
[127mm]
6"
[152mm]
Drill (3) Pilot Holes
(refer to hole size chart)
Mount Bracket with (3)
1/4-20 Self-Tapping Screws.
Tighten Securely.
Spring
Figure 4.5.1
Tethered Operator Station Storage Bracket Hole Dimensions
4.5.2 Receptacle Mounting
Select proper location for mounting receptacle. Receptacle is 1-1/4” x 1-1/4” and ½” deep. (32 mm x 32 mm x 13 mm) Allow extra
room behind receptacle for wires. Refer to Figure 4.5.2 for hole dimensions.
Drill (4) .098”
(#40) Holes
7/8”
(22 mm)
7/8”
(22 mm)
25/32”
(20 mm)
HOLE LAYOUT
MOUNT RECEPTACLE WITH
#4 SELF-TAPPING SCREWS.
TIGHTEN SECURELY.
INSTALL
CHAIN CONNECTOR
UNDER SCREW HEAD
Y5310 TETHER RECEPTACLE
Y5320 CLOSURE CAP
Figure 4.5.2
Tether Operator Station with Display Receptacle Hole Dimensions
