Tascam GB-10, Owner'S Manual

Page: 58 / 100

58
TASCAM GB-10
Searching forward and backward
During playback or when stopped (or paused), press and hold
the
Ô /  button to search backward/forward. Release the
button to return to the previous state.
Use the “
CUE/REV SPEED
” item on the
SETUP
screen to set
the search speed. (See “System settings(SETUP)” on page 80.)
Press the
Ô
/

button briefly to search backward/forward
to the beginning/end of the file.
Press the same button again briefly to change the search
speed. The speed options are: x2, x5, x10, x20, x40 and x120.
NOTE
Searching backward/forward continues only until the
beginning/end of the current file. Searching will not continue
into the previous or next file even if you continue to hold the
button.
Adjusting the playback volume
Use the OUTPUT (+/–) buttons to adjust the volume level
output from the /LINE OUT jack. While being adjusted,
the volume level is shown in a pop-up at the bottom of the
display.
NOTE
If you turn the guitar input off, the playback level returns to its
original level.
If the guitar input is on, and you have used the BALANCE
button to lower the volume of the playback (“
BALANCE
”)
to overdub an audio file, when you play back that file, the
playback monitoring level will be lower than it was when
recording. In this case, use the BALANCE button to set
“
BALANCE
” to its maximum.
7–Playback