3 Beeps
Ignition
9.4 HOME function TR2 and TR2-P control:
9.2 TRIGGERING REPORT:
Deactivating the alarm with 4 Beeps, it reports that a triggering has
occurred. To know the cause, press right after deactivating the alarm by the control. The
number of beeps reports the cause.
Use the HOME button of the TR2 or TR2-P controls, it is possible to activate the automatic gate or
residential alarm, without having to use the auxiliary module, only recording the control in the gate or
alarm central.
Compatible with CODE LEARNING fixed code system.
The inclination sensor in saving mode does not trigger with a simple change of the position of the
motorcycle. A strong touch, such as sitting on the motorcycle seat, is required to exit economy mode.
Disable the alarm via remote control as soon as the lights flash.
1 Beep
Inclination Sensor
9.3.2 INCLINATION SENSOR IN SAVING MODE.
ALeaving the motorcycle stationary with the alarm activated or not, for more than 24 hours, the BATTERY
SAVING mode ‘Sleep’ is activated. In this mode, the motorcycle's battery consumption is reduced 17 times
compared to normal consumption. All sensors remain active and trigger the alarm in case of any change in
the signals. For this saving to happen, the RF system (Remote Control Receiving System) is disabled, so the
alarm will not respond to remote control commands.
Obs.: Ignition has no triggering limitation.
9.1 SHUTDOWN - TRIGGERING LIMITATION:
In the event of an alarm triggering, the alarm activates
the SIREN and the light flashes for 45 seconds. Another 5 seconds, check the sensors again. Four
triggerings from the same sensor cancel it, keeping the others active. The sensor will be activated the
next time the alarm is activated by the remote control.
9.3.1 HOW TO DEACTIVATE THE ALARM IN SAVING MODE?
9.3 SLEEP FUNCTION / SAVING
(save motorcycle battery)TARAMPS Alarms exclusivity. Function
enabled in the standard configuration Beep 10.
Turn on the ignition or move the motorcycle (with the inclination sensor enabled), the alarm will return
to normal operation, activating the RF system (remote control reception). Disable the alarm via remote
control as soon as the lights flash. Otherwise, another 5 seconds activates the siren, flashes the lights
and shuts off the engine. If the remote control cannot be used, the alarm can be disabled by the
ignition password.
item 14
2 Beeps
Auxiliary Sensor
9.3.3 DISABLE THE INCLINATION SENSOR:
By activating the alarm and disabling the inclination
Sensor (accelerometer) through the control,
, lThe alarm does not go off when the motorcycle is
ítem 5.9
inclined, but when the ignition is switched on or the trunk is opened, if installed. To return to normal
operation, disable and enable the alarm by remote control.
Record the TR2 or TR2-P control according to the manufacturer's instructions, as if it were a control of the
same brand of gate or residential alarm.
08
9) Alarm Functions
Summary of Contents for Tarsafe TMA 10 G4
Page 1: ...MANUAL MOTORCYCLE ALARM TMA 10 TMA 20 TMA 30 ...
Page 16: ...MN_016030_R01 ...