Taramps Tarsafe TMA 10 G4, Manual

Page: 13 / 16

14) Ignition Password - Disarm Alarm without the Control
1 beep enables;
2- Turn the contact on and off according to the second digit, (standard 3)The alarm will respond
after 2 seconds:
How to use:
2 beeps disable.
Wait 3 seconds;
1- Turn the contact on and off according to the first digit, (standard 3).
In case of problems with the remote control (low battery, damage or loss), it is possible to disable the alarm by the
ignition password, even with the alarm triggered. Disabled, the alarm does not work until enabled by the ignition
password.
14.1) Change ignition password
5- Wait 2 seconds (1 beep confirms);
6- Turn the contact on and off according to the second digit;
Standard password _3_ : _3_ NEW PASSWORD ____:____
1- Turn on the ignition;
3- When releasing the alarm, it sounds 4 beeps and the turning signals will remain on.
4- Turn the contact on and off according to the first digit;
After a few seconds, a long beep confirms that the new password has been entered. If there are 2 beeps, there was a
recording error, you have to do the whole process all over again.
2- touch the OR/BL wire on GND until beep 4
7- At the end leave the ignition off.
ON
START
OFF
ON/OFF
1
ON
START
OFF
ON/OFF
2
ON
START
OFF
ON/OFF
3
+3 S
STANDARD PASSWORD
NEW PASSWORD
Select Beep 4 function
OR/BLK
to
GND
ON
START
OFF
+ 2 Seconds, 1 Beep +
+ 2 Seconds, 1long Beep
programming OK
ON
START
OFF
ON/OFF
on/off
1° digit
??
ON
START
OFF
ON/OFF
on/off
2° digit
??
ON
START
OFF
ON/OFF
1
ON
START
OFF
ON/OFF
2
ON
START
OFF
ON/OFF
3
12