Taramps Tarsafe TMA 10 G4, Manual

Page: 12 / 16

alarm off.
Activate Auxiliary output 2
- Press the OFF button on the remote with the ignition off and the
+ than 2
seconds
Programming
- Turn on the ignition.
- The alarm will sound according to the current setting:
1 Beep = Secret Button
- Touch the OR/BLK wire on GND until beep 13.
3 Beeps = AUXILIARY Output 2 Hold
2 Beeps = AUXILIARY Output 2 Pulse
In this configuration, with alarm and ignition off, pressing the remote control DISABLE button for more than 2
seconds, activates the output, when releasing the DISABLE button the output will remain activated.
1) Assault Mode by Secret Button
Configuration for installation of the button for the ASSAULT MODE BY SECRET BUTTON. Enabling the Secret item 8.
Button automatically changes the setting of the Orange wire.
2) AUXILIARY 2 output - pulse.
In this configuration, with alarm and ignition off, pressing the remote control's DISABLE button for more than 2
seconds, it activates the output and when the button is released, it deactivates.
3) AUXILIARY 2 output - retention
To turn off the output, press the remote's OFF button again.
Operation Example.:
To start the motorcycle, connect the ORANGE wire to the relay to turn on the ignition and the GRAY wire to the relay for
the start button.
- Press the OFF button on the control until the ignition is on, and press the AUX button until the engine starts.
Since the ORANGE wire (Auxiliary 2 output) is in hold mode, the ignition reamains on, keeping the engine running.
- To turn off the engine, press the OFF button on the control again.
To change, touch the OR/BLK wire on the GND the number of times related to the
desired setting. At each touch, the alarm confirms with 1 beep. After turning off
the ignition, beeps confirm the new setting.
ATTENTION: Risk of accidents in the event of incorrect installation.
For motorcycles where it is possible to start with the gear out of neutral, it is essential to install and
configure the GREEN wire connected to the neutral signal, so that accidents do not happen.
13) Setting Auxiliary Output 2 - ORANGE wire
Select Beep function 13
OR/BLK
to
GND
Setting
Example:
1x secret button
2x Aux. 2 pulse
3x Aux. 2 retention
11