Taramps Tarsafe TMA 10 G4, Manual

Page: 3 / 16

4) Record NEW control in the alarm Central
possible to record up to 4 controls, when recording the 5th ,it removes the first.
PROCEDURE:
- touch the OR/BLK wire on GND until beep 3.
- When releasing, 1 long beep and the turning signals will stay on;
To exit setup, turn off the ignition.
Press the AC DEACTIVATE keys of the control simultaneously,
3 Beeps confirm the recording.
Select Beep 3 function
OR/BLK
to
GND
3 flashes = line G1 to G3
A - Hold down the Home and Auxiliary keys;
B - Release after the LED turns off;
4 flashes = G4 line ahead
Change G3 / G4 codes - of TR2 and TR2-P controls
C - The LED flashes indicating the new code system:
Controls manufactured after June/2019.
ATTENTION: This function only applies to
3) Remote Controls*
Ÿ
Operating Frequency 433.92MHz
Ÿ
Anti-ClonningTechnology (Hopping Code)
Ÿ
Transmission System Against Jammer
Ÿ
1 Battery 3V - CR 2032 LITHIUM
Illustrative
images
and
may
be
different
from
the
real
one.
* See item 18 which remote control belongs to which model of the Alarm.
Any control model can be purchased separately.
‘‘This equipment operaters in a secondary mode, that is, it does not
have the right to protection against harmful interference, even from
stations of the same type, and it cannot cause interference in systems
that work in a primary mode.’’
Changing the Control Battery.
USE A GOOD
QUALITY
BATTERY
Open the plastic box carefully on the
sides.
Use CR2032 batteries.
Replace the battery, observing the
polarity (+) and (-).
Control
TR2
Control with
PRESENCE
TR2-P
G4 controls functions (made from June 2019)
Jammer is when there is another control transmitting near the alarm central, making it impossible to activate or
deactivate the alarm through the control that is recorded in the central.
- Code G3 (for alarms TARAMPS G1 to G3).
- Anti Jammer function. EXCLUSIVITY IN THE G4 TARAMPS LINE.
-G4 code (exclusive to the TARAMPS G4 line).
02
HOME ON OFF AUXILIARY