TANDBERG TT-1222, Reference Manual

Page: 111 / 132

Front Panel LCD Menus
Reference Guide: TT1222 4:2:0 Professional Receiver Page C-23
ST.RE.TT1222.2
C.5.21 LS Data Menu
The LS data menu configures the parameters for the output of RS-232
data, extracted from the transport stream.
Table C.29: LS Data Setup Menu
Menu title: SET:LS DATA Description Section
Mode: Sets the operation mode of the Asynchronous data output.
Off - No data is output on the port.
Manual - The data from the PID selected in the AUX PID menu is
output on the port.
Diagnostic - The diagnostic information from the unit is output on
the port.
Default = Off. ----
Aux PID: Selects the PID that is output on the port if “Mode” is set to manual.
Default = 0016. ----
Buff Use %: Shows the fill level of the RS-232 buffer. If this buffer cycles up to
100% constantly, it is likely that data is being lost due to buffer
overruns.
NOTE…
This is a status item and cannot be set by the
user.
----
Data Port > Enters the Data Port submenu C.5.22
Profile: Selects the encoding format used by encoder/transmitter.
Streamed - DVB format.
Piped – TANDBERG Proprietary format
Format #2 - TANDBERG Proprietary format
TS-Packets - The whole Transport packet payload
PES Payld - The whole PES packet payload
Default = Streamed. ----
LS Output > Enters the LS Data Output submenu C.5.23
The RS-232 data output cannot exceed the data rate configured in the
communication menu. If the outgoing data rate is higher, information will
be dropped in an unpredictable fashion.
The transmitted PID’s contents should have a lower rate than 115200
bit/s, since this is the maximum output rate. If the rate is higher, burst
mode can be used, as explained in Section C.5.23 .