TANDBERG TT-1222, Reference Manual

Page: 113 / 132

Front Panel LCD Menus
Reference Guide: TT1222 4:2:0 Professional Receiver Page C-25
ST.RE.TT1222.2
C.5.23 LS Output Menu
The LS data output menu controls the output format and buffering of the
low speed data.
Table C.31: LS Data Output Setup Menu
Menu title: SET:RS232 LS O/P Description Section
O/P Format: Sets the output format of the low speed data port.
Bin - Provides a binary output.
Hex - Provides a hexadecimal output with the most significant
nibble first
Default = Bin. ----
Buffering: Set the buffering mechanism used for the low speed data port.
Flow - Transmits the selected PID directly without buffering.
Burst - This mode can be used for analysing the input sequence
of a PID that has higher transfer rate than the UART can handle
(max 115.2k). The buffer will fill up and dump the contents out on
the serial line. The buffer size is in both cases 16 kbit/s.
Default = Flow. ----
C.5.24 ASI Output Menu
Table C.32: ASI Output Setup Menu
Menu title: SET:ASI OUT Description Section
Output: This item selects the preferred ASI output.
Scramble – If the input is scrambled, the output will also be
scrambled.
Descramble –The receiver will output a descrambled service
when possible.
Default = Scrambled.
NOTES…
1. The receiver must be set up to
descramble a scrambled service.
2. The output will always be 188 packet
size.
----