TANDBERG TT-1222, Reference Manual

Page: 16 / 132

Introduction
Page 1-8 Reference Guide: TT1222 4:2:0 Professional Receiver
ST.RE.TT1222.2
Edit and Save
In the edit mode, when the correct value is in place, exit and save by
pressing multiple times to the right, to move the cursor outside the edit
area. When the cursor leaves the edit area, the new setting will be saved,
and the keypad will revert to the navigation mode.
Cancel an Edit
In the edit mode, if you have incorrectly entered a value, cancel and exit
by pressing multiple times to the left, to move the cursor outside the edit
area. When the cursor leaves the edit area, the previous setting will
reappear, and the keypad will revert to the navigation mode.
NOTE…
Keypad access may be locked, easily recognised by the small lock in the top left corner of the display.
To navigate the menus, escape the locked mode by pressing left, right, 3 x left and then 3 x right in
sequence. This will take you from the default status screen, to the main menu.
1.4.3 Front Panel LED
The unit is fitted with one LED, showing the status of the unit. When the
LED lights up red, an alarm condition has been met, according to the
alarm set-up described in Annex D, Alarm Categories and Conditions.
1.4.4 Conditional Access – DVB Common Interface
There is one slot on the rear of the unit, to allow the insertion of a DVB
Common Interface Module.
1.4.5 Rear Panel
All input and output connectors are located on the rear panel. Connector
descriptions are given in Chapter 2, Installing the Equipment.