TANDBERG TT-1222, Reference Manual

Page: 44 / 132

Operating the Equipment Locally
Page 4-6 Reference Guide: TT1222 4:2:0 Professional Receiver
ST.RE.TT1222.2
4.4.2 Setting Up an Additional Audio Channel
Configuring this output is very similar to configuring the TV output.
NOTE…
Audio 1 is associated with the TV Service. An additional audio is available and referred to as “Audio 2”.
To set up the Audio 2 service, select the service and language according to
Table 4.3.
Table 4.3: Setting Up Audio2 Services
Step Action Result
1. Go to the Audio 2 Service menu, located under
the Setup menu. The display will read “SET: AUD2 SERVICE” on the top
line.
2. Repeat pressing the up and down arrows, until
the selected service is displayed. If Service names
do not exist for the chosen TS, continue to item 4. The second line will scroll between all the services
available in the transport stream.
3. Pressing right will select the displayed service. A small check mark is displayed in front of the service,
indicating that it is selected.
NOTE…
If a TV service is selected, only the audio
of this service is decoded.
4. It is also possible to select service based on
service ID. Keep on scrolling up until the display
read “Service ID > xxxx”. This enables you to select services that are not named in
the SDT.
5.
By pressing right once, the keypad enters edit
mode, and keying in the SID is now possible. After entering the SID and leaving edit mode, the correct
service is chosen and saved.
6. Return to the Audio 2 Service menu. The display will read “SET: AUD2 SERVICE” on the top
line.
The ‘Aud2 Lang’ menu item here will enable you to select
the correct audio language component from the service.
7. Exit the Audio 2 Service menu once you have
selected the correct service and language. This will take you back to the Setup menu.