Options and Upgrades
Page 3-34
Reference Guide: evolution 5000 E5780 and E5782 Encoder
ST.RE.E10135.4
Ethernet Output Connector
An RJ-45 connector provides a 100/1000BaseT Ethernet port.
Table 3.38: RJ-45 Connector
Item Specification
Connector Type
RJ-45
Connector designation
10/100 BT
Pin-out
1
Tx Out (+)
2
Tx Out (-)
3
Rx In (+)
4
Not
Connected
5
Not
Connected
6
Rx In (-)
7
Not
Connected
8
Not
Connected
Table 3.39: Ethernet Port (IP Output Card)
Item Specification
Safety Status:
SELV
Connector Type:
8-way RJ-45
Connector Designation:
10/100 BT
Signal Type:
10/100BaseT Ethernet (IEEE 802.3/802.3u)
Transport Stream Rate:
1.5 – 80 Mbit/s
3.14.4 Dual
Control
This menu appears if the card EN5900/HWO/IPTSDUAL is installed in the encoder. This
allows direct connection to a redundant IP/Ethernet network as it has two separate Ethernet
connections. The menu structure is shown in
•
Dual IPNIC control: specifies the parameters associated with the card such as the IP
address of the ports.
•
Dual IPNIC TS: there is a menu associated with each Transport Stream output. At the
moment, there is only the capability for a single Transport Stream output but dividing the
Transport Stream into its component services is on the roadmap.
