User guide
Advanced menu
99
Form length (Forml)
The
Formlen
function allows you to set the basic form length to
meet your requirements. 11 inches are usual in the USA, as op-
posed to 12 inches in Europe.
Select the
Forml
menu (2).
Setting options:
12
oder
11
Inch
Default setting:
12 inches
for 220–240 V printers
11 nches
for 120 V printers
The value defined here is set in all five menus and for all paper
paths. The setting made here is not changed by loading the default
(factory) settings by pressing all four function keys; see section
Key
functions when turning on the printer
(page 34).
Confirm the setting by pressing the
Set
(1) key.
Automatic gap adjustment
(AGA)
This function allows you to switch the Automatic Gap Adjustment
(AGA) off or on.
Select the
AGA
menu (3).
Setting options:
Off/On
Default setting:
On
AGA=On
: printer checks paper thickness and changes gap adjust-
ment if necessary (default). Measurements take place
– after power-on
– in single sheet mode: for each sheet
– in tractor mode: whenever changing the paper path, when
loading paper
AGA = Off
: selects manual gap adjustment; the value can be set for
each paper source and each of the five menus available.
Confirm the setting by pressing the
Set
(1) key. The printer automat-
ically leaves test mode and assumes online mode.
Formlen AGA
Online
Setup
Back Next
2
1
3
4
Formlen=12" *
Online
Setup
Set < > Exit
2
1
3
4
Formlen AGA
Online
Setup
Back Next
2
1
3
4
AGA=On *
Online
Setup
Set < > Exit
2
1
3
4
