ETP-500
Series Analog Call Station
Installation & Operation Manual
Page
9
of
23
Rev. 3/16/2017
Copyright 2017 Talkaphone
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone All rights reserved.
Operation Codes
The following codes can be used to perform functions during a conversation:
Command Function
*
Enter Programming Mode when in Communication Mode (See *78*, p.7)
6
Provides a momentary closure to the Output #1
*9*
Elicit the phone ID number
*25*
Turn ON the Auxiliary Output #1
*26*
Turn OFF the Auxiliary Output #1
*28*
Turn ON the Auxiliary Output #2
*29*
Turn OFF the Auxiliary Output #2
#
Immediately disconnect a call
PBX/Timing Configuration Codes
Command
Function
*14*1*
MODE I: Sets Talkaphone unit for Central Office Trunk Line
(default)
*14*2*
MODE II: Sets Talkaphone unit for PBX
when an EC-8 Consolidator is
used
*14*3*
MODE III: Sets Talkaphone unit for PBX
when an EC-8 Consolidator is
not
used
*17* …[minutes]*
Sets the conversation timer (1
–
4,320 minutes) (
default is 12
minutes)
*18*
…[ring cycles]*
Sets the number of ring cycles (3
–
9) before the Talkaphone unit
aborts a call and either redials the primary number or switches to the
secondary number
(default is 9 ring cycles)
*100*
0.5 second hang-up on busy or no answer
(default)
*101*
2.25 second hang-up on busy or no answer
*102*
51ms on/off dialing speed
(default)
*103*
102ms on/off dialing speed
1
*40* …[0 –
10]*
Sets delay before phone dials (0
–
10 seconds)
May be used to wait to obtain PBX dial tone (
default is 2 seconds)
*53*
Sets the Talkaphone unit to disconnect if the Guard Station is silent for
60 seconds
*54*
Talkaphone unit will not disconnect if Guard Station is silent (
default)
*55*
Sets Talkaphone unit to disconnect if the Guard Station is silent for 30
seconds
*21*
Configures Talkaphone unit for use with a Rolm PBX or a Mitel PBX
*22*
Cancels *21* command
(default)
You can configure your Talkaphone unit for a variety of environments. For example, if your
communication line is a PBX extension, you must configure the Talkaphone unit to recognize the PBX
system by programming the following functions:
Telephone line type (Mode II or III): *14*[2 or 3]*
Number of ring cycles before the Talkaphone unit aborts a call and either redials the primary
number or switches to the secondary number: *18*…[ring cycles]*
Talkaphone unit disconnects after 30 seconds of silence, *55*
When the Talkaphone
unit’s extension is setup as a
"ringdown" or "hot line", the Talkaphone
unit has to be programmed with a phone number: *13*…[
5-digit number]* (Example:
*13*12345*).
