ETP-500
Series Analog Call Station
Installation & Operation Manual
Page
14
of
23
Rev. 3/16/2017
Copyright 2017 Talkaphone
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone All rights reserved.
Keypads (ETP-500ECK, ETP-500NCK)
Some Talkaphone models have a keypad. These models are denoted with the letter "K" in the model
number. When the black call button is pushed, the user will hear a dial tone and can then use the
standard 12-key pad to dial any number that has been authorized for that telephone line. When the
called party answers, simply speak hands-free. When the called party hangs-up the unit will
automatically disconnect.
Anytime the red Emergency button is pushed, the phone will automatically place the emergency call. If
a conversation is taking place it will automatically be disconnected and the emergency call placed. To
hang up the phone when placing a non-emergency call, simply press the lower button a second time.
Note: The black call button is used to take the phone off hook before placing a call with the keypad.
This button
cannot
be programmed with an autodial phone number and it
cannot
be used to
automatically activate an auxiliary output.
5. 10-Number Autodialing Keypads (-K2 Models like ETP-500NCK2)
Programming
To program the autodialing phone numbers for buttons 0-9, use the following codes:
*13* …[up to 11 digits]*
Programs the phone number called by the RED button (if available)
*23* …[up to 11 digits]*
Programs the phone number called by keypad button #0
*80* …[up to
11 digits]*
Programs the phone number called by keypad button #1
*81* …[up to 11 digits]*
Programs the phone number called by keypad button #2
*89* …[up to 11 digits]*
Programs the phone number called by keypad button #3
*90* …[up to 11 digits]*
Programs the phone number called by keypad button #4
*91* …[up to 11 digits]*
Programs the phone number called by keypad button #5
*92* …[up to 11 digits]*
Programs the phone number called by keypad button #6
*93* …[up to 11 digits]*
Programs the phone number called by keypad button #7
*94* …[up to 11 digits]*
Programs the phone number called by keypad button #8
*95* …[up to 11 digits]*
Programs the phone number called by keypad button #9
To set the dialing speed, use the following codes:
*96*
51ms on/off dialing speed
(default)
*97*
102ms on/off dialing speed
For other programming information, such as how to program for operation on a PBX, timing codes, etc.,
see Section 3 (p.5).
Operation
If the phone has a red button, pressing it will automatically dial the pre-programmed number and
operate the auxiliary outputs if it is programmed to do so. On these units, there is no backup number
for the top button.
When the black call button is pushed, the user will hear a dial tone and can then use buttons 0-9 on
the-keypad to dial one of ten pre-programmed numbers. When the called party answers, simply speak
hands-free. When the called party hangs-up the unit will automatically disconnect. To hang up the
