ETP-500
Series Analog Call Station
Installation & Operation Manual
Page
4
of
23
Rev. 3/16/2017
Copyright 2017 Talkaphone
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone All rights reserved.
2. Hardware Installation
Installation should be performed by qualified personnel only in accordance with the National Electrical
Code and other federal, state and local statutes and building codes. Using shielded cable is
recommended to avoid noise, hum, and other operational anomalies.
You will need a TS-20 Pin-in-Torx screwdriver or bit to complete this. If you do not own one, you may
purchase one from your local industrial supply store or from Talkaphone. Contact your Talkaphone
distributor for purchasing information.
Talkaphone model MS-600 Mounting Sleeve is designed to accommodate the ETP-500 Series Analog
Call Stations. Contact your distributor or Talkaphone Co. for more information.
Talkaphone offers several mounting accessories for our outdoor flush mounting phones, ranging from
simple back boxes to towers with pan-and-tilt camera domes. For detailed mounting accessory
installation instructions, consult the literature that accompanies the relevant mounting accessory. Each
phone comes with six (6) TS-20 Pin-in-Torx security screws. If you do not own this type of screwdriver
or bit, you may purchase one at your local industrial supply store or from Talkaphone. Contact your
Talkaphone distributor for purchasing information.
1. Plug the RJ11 connector on the silver cable into an RJ11 receptacle that is connected to the phone
line (Red is ring and green is tip). This is connected to the small 2 pin terminal block located near the
bottom center of the circuit board. This terminal block will pull straight up off the pins to reveal the
labels
“R”
(for RING)
and “G”
(for TIP
). Typically, the red wire is “R” or RING and the green wire is
“G” or TIP.
2. Connect the green wire to Earth Ground, this is connected to the faceplate using the grounding stud
that is located between the speaker and the button.
3. Your phone has two auxiliary outputs and may have one auxiliary input. The auxiliary outputs are
rated at a maximum of 50 mA at 30V DC or AC. The six (6) pin terminal block located at the top left
corner of the board is for these auxiliary connections.
a. Output 1 is the Red and White wires, these are connected to terminals
OUT_1A
and
OUT_1B
respectively.
b. Output 2 is the Orange and Black wires, these are connected to terminals
OUT_2A
and
OUT_2B
respectively.
c. Input #1 is the Brown and Blue wires, these are connected to terminals
IN_A
and
IN_B
respectively.
To use the auxiliary input feature, contact Talk-A-Phone to request an
ETP-AUXIN-KIT
at no charge.
4. Place the phone into its mounting accessory and secure with six (6) TS-20 Pin-in-Torx security
screws (included).
