Area of Rescue Command Unit
Installation Guide
Model AOR-24 / Model AOR-32
Product Revision 2.0
Page
12
of
23
Rev. 3/8/2022
Copyright 2014-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
18. Connecting Backup Batteries:
Install the backup batteries and connect them to the power supply board by inserting the
connector onto the header pins located on the bottom right of the internal power supply.
Match and connect the cables marked
“3”
through
“10”
to the terminals marked
“3”
through
“10”
.
WARNING:
The order in which 100-240 VAC 50-60Hz or backup batteries is
connected does not matter. However, once either backup battery is connected OR
the primary 100-240 VAC line is energized, THE COMMAND UNIT WILL BE
ENERGIZED OR
“HOT”.
It is the installer’s obligation to ensure compliance with all national, regional, and
local regulations.
It is the installer’s obligation to mark the “date of installation” on each battery.
