Area of Rescue Command Unit
Installation Guide
Model AOR-24 / Model AOR-32
Product Revision 2.0
Page
18
of
23
Rev. 3/8/2022
Copyright 2014-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
List of Programming Codes for the AOR-CSE Station
Command
Memory Slot
Function
0-20 digits
#00
Primary autodial phone number
*
0-20 digits
#01
Secondary autodial phone number
*
0-20 digits
#02
Third autodial phone number
*
0-20 digits
#03
Fourth autodial phone number
*
0-20 digits
#04
Fifth autodial phone number
*
6 digits
#18
Timing/dialing options. For further details, see
“Timing/Dialing
Options for the AOR-
CSE Station”
below.
[Default 234721]
6 digits
#19
Change the security code
[Default 827827 or TAPTAP]
* 7
Add 4-second pause at any point of the dial string
[Enter No Digits]
#00 through #04
Clear autodial phone numbers
# 7
Exit programming mode and disconnect
# # #
Reset to factory defaults
*
For
Remote Mode with CO Line Mode
,
7
can be used as the phone number to reach the local
phone and
9
can be joined with a 10-digit phone number to route the call through the
“TELCO IN”
port.
NOTE:
After each AOR-CSE Station programming code, a double-beep indicates the code has been
accepted. Four (4) beeps indicate an error
—re-enter the code again.
